Jointer Test 2 Checking Depth of Cut

	Sign In Sign-Up

Jointer Test 2 Checking Depth of Cut
Though this may seem like "overkill", this test will allow you to "calibrate" the scale on your jointer.

With the A-LINE-ITÔ assembled as shown in the photo to the left, "zero" the dial indicator on the outfeed table of the jointer.

Lift the tip of the indicator, and slide the A-LINE-ITÔ to position the tip of the indicator on the infeed table of the jointer.

When you release the tip of the indicator, and lower it onto the infeed table, the reading (which will be below the initial zero) will show you the difference in position between the two tables. To assist those of you who are not familiar with using a dial indicator, you should refer to the decimal-to fraction conversion chart below to determine exactly what these readings mean. Once you have found the fractional equivalent, you can adjust the scale or pointer on your jointer to calibrate the readings.

Return to A-Line-It On-line Manual Main Page